Tektonology3D-printable church solutions

Kneeler Boot - Compound Bonded

Kneeler Replacement Parts

A two-piece boot system with a rigid PLA upper shell for stability and a soft TPU floor pad for grip. Parts are bonded together with adhesive.

Print Settings
Upper Boot
Polymaker PLA Pro (Black) | 4 Wall Loops | 35% Gyroid Infill
Floor Pad
TPU 90A | 4 Wall Loops | 35% Gyroid Infill | Print Speed < 40mm/s
Assembly Guide
  1. Clean surfaces: remove any stringing from the internal wedge cavity.
  2. Apply Glue: place 2-3 drops of Loctite 406 inside the PLA upper boot cavity.
  3. Press-Fit: press the TPU floor pad wedge into the PLA cavity until flush.
  4. Cure: let sit for 60 seconds before installing on the pew.
Downloads
↓ Upper Boot (PLA)↓ Floor Pad (TPU)