Tektonology3D-printable church solutions

Kneeler Boot - Monolithic Bonded

Kneeler Replacement Parts

A single-piece boot that slides over the pew kneeler leg and is secured with adhesive. Simple, rigid, and durable.

Print Settings
Upper Boot
Polymaker PLA Pro (Black) | 4 Wall Loops | 35% Gyroid Infill
Assembly Guide
  1. Clean the kneeler leg end, removing any paint or debris.
  2. Apply 2-3 drops of Loctite 406 inside the boot cavity.
  3. Press the boot onto the leg until fully seated.
  4. Let cure for 60 seconds before use.
Downloads
↓ Kneeler Boot